RE: right C++ code to control my robot?

Peverel — Wed, 25 Feb 2009 00:01:10 GMT

Mema,

I think there is an issue with the way you are using the Serializer serial port (TTL). To the best of my knowledge there is only one serial port on a serializer and that is used by the bluetooth module you are communicating to the board with. This means that the TTL level port you have the second stepper motor attached to cannot be accessed and thus you could never command the second stepper motor.

Pev

right C++ code to control my robot?

mema — Thu, 15 May 2008 06:15:10 GMT

Hello

Can u help me to select the right C++ code to control my robot?

My robot have 2 bipolar stepper motors, the first one will be directly connect to the Serializer and it will have to move CW and CCW with the same motor speed

For the other stepper motor will connect to an external stepper controller (via the TTL serial port in the Serializer) and this motor should work also CW and CCW with the same motor speed

So plz tell me what are the codes that I should but in the VB commend. I develop the VB layout but don’t know what codes is should put inside each commend bottom. There are 4 bottoms (to allow the user to control the robot so the robot will go to the 4 directions up, down, right n left)

The big picture: when the user will click in the right arrow on the keyboard the robot will move to the right direction.

By the way Serializer that i use will interface using Bluetooth serial interfaces modules

All the best

Mema

RoboticsConnection User Forum / RoboticsConnection Software Support / Serializer C++ Library / right C++ code to control my robot? / Latest Posts

RE: right C++ code to control my robot?

right C++ code to control my robot?